Sampo DR-S0426 Manual de Instruções descarregar pdf (Página 27)

CHAPTER 7

HARD DRIVE INSTALLATION PROCEDURES

1. Hard drive jumpers need to be set properly in order to make DVR function correctly.

2. Instructions below are for second hard drive installation. If you prefer to have only one

drive, please ignore instruction below. Remove DVR top cover by taking out screws

from location shown below:

3. Below picture indicates DVR which one without a H.D.D installed.

4. Please refer to the instruction from hard drive manufactory for correct jumper setting

on (master /slave) mode of the hard drive, mounting the hard drive over DVR base by

facing IDE interface to DVR main board. Match screw holes from bottom to bottom of

hard drive and the DVR. Turn over the DVR from top to bottom side and then mounting

up the hard drive by using screws from attached accessory pack as picture below:

①

②

③

⑤

⑥

④

1 2 ... 22 23 24 25 26 27 28 29

Sem comentários

Sampo DR-S0426 Manual de Instruções Página 27